Procedure C2: Replacement Of The Coder - SAMES KREMLIN Inorecip V User Manual

6.3.2. Procedure C2: Replacement of the coder

After 3 to 5,000 hours of operation, or in case of accidental damage, it may be necessary to
change the coder. Caution: The coder is very fragile, especially its connection terminals.
For proper operation of the equipment, it is recommended that the antistatic toothed belt on
the carriage is correctly adjusted.
• Step 1: Move the carriage down to the bot-
tom stop.
• Step 2: Switch off the power supply to the
Inomotion and disconnect the electrical
connections to the coder.
• Step 3: Remove the side panel (1) and the
access trap door.
• Step 4: Unscrew the coder cable.
• Step 5: Remove the nut (3) from the coder
anti-rotation plate
• Step 6: Remove the coder from the motor
shaft by unscrewing the screw (4).
• Step 7: Remove the coder anti-rotation
plate by unscrewing the screws (5).
• Step 8: Proceed in reverse order for reas-
sembly.
Index revision : A 34 7140