SAMES KREMLIN Inorecip V User Manual page 7

WARNING : Equipment performance is only guaranteed if original spare parts distributed by
SAMES KREMLIN are used.
WARNING : This equipment must only be used in projection locations in accordance with EN
16985. The equipment should only be used in well-ventilated areas to reduce health, fire and
explosion hazards. The efficiency of the exhaust ventilation system must be checked daily.
1 The operator must wear shoes according to standard EN ISO 20344 and the insulation
resistance measured must not exceed 100 MΩ.
2 The protective clothes, including gloves, must conform to standard EN 1149-5 and the
insulation resistance measured must not exceed 100 MΩ.
3 Using individual protection equipment will limit the risks of contact and/or inhalation of
toxic product, gas, vapours, fog or dusts that can be produced while using the equip-
ment. The user has to follow the coating product manufacturer's recommendations.
4 Appropriate measures must be taken to prevent, during periods of non-use and/or when
the equipment is out of service, that potential energy is present in the equipment.
5 The ambient operating temperature must be between 0° and 40° C.
6 The Inorecip V and Inomotion equipment must be maintained regularly in accordance
with the indications and instructions given by SAMES KREMLIN.
Repairs must be carried out in strict accordance with these instructions.
7 The use inside the booth of open flames, incandescent objects, devices or objects that
can generate sparks is prohibited.
It is also forbidden to store flammable products or the containers containing them near
the cabin and in front of the doors.It is necessary to keep the surrounding area clear and
clean.
8 Earthing is required of all conductive enclosures of electrical equipment and all conduc-
tive components in potentially explosive atmospheres by conductive connection to the
earth terminal.
9 It will be necessary, in the spraying area, to have an antistatic floor such as bare concrete,
metal grating, etc...
10 In case of an emergency, the equipment can be switched off via emergency stop but-
tons located on the powder booth or on the control cabinet.
11 Ensure that the pneumatic pressure inside is completely exhausted before adjusting or
servicing pressurized systems or parts.
12 Disconnect, lock out and switch off electrical equipment before servicing electrical
equipment.
Index revision : A 7 7140