Replacement; Procedure C1: Replacement Of The Antistatic Toothed Belt - SAMES KREMLIN Inorecip V User Manual

6.3. Replacement

6.3.1. Procedure C1: Replacement of the antistatic toothed belt

WARNING : Before removing the belt, it is necessary to secure the counterweight
To do so, the projectors mounted on the Inorecip V have been removed from the booth:
Move the altitude carriage down to altitude until it touches the lower stop.
• Move the altitude cart down until it touches the lower stop.
• Secure the counterweight carriage by placing a cleat (100x100) of a size adapted to the
height between the counterweight carriage and the base of the Inorecip V.
• Slacken the belt by loosening the two tensioning screws
• Note the position of the locking plates on
the altitude carriage and on the counte-
rweight carriage as they should be reas-
sembled in
position, then loosen the upper (A) and
lower (B) locking plates and remove the
belt.
• Proceed in the reverse order for reassem-
bly.
• Adjust the tension of the new belt
page 25).
Index revision : A
approximately the
(see § 4.8
(see § 4.8 page
same
(A)
(B)
33
25).
7140