Adjustment Of The Stops; Loading The Reciprocator - SAMES KREMLIN Inorecip V User Manual

4.5. Adjustment of the stops

The stops limit the stroke of the altitude carriage
Adjustment procedure for the two stops:
• Step 1: Remove the side panel.
• Step 2: Move down the height carriage
until the lowest projector is about 50 mm
above the lower edge of the slot of the
powder booth
• Step 3: Loosen the two M10 nuts on the
lower plate (B) and position the mechani-
cal rubber stop in contact with the car-
riage.
• Step 4: Tighten the two M10 nuts.
Proceed in the same way to position the
upper stop (A) at the required stroke,
taking care to respect the height of the slot
in the booth
• Step 5: Reinstall the side panel.
Note: When adjusting the stops, make sure that
the power supply cables for the position sensors
remain free.
WARNING : After adjusting the mechanical stops, the "MIN POS" and "MAX POS" values
28) must be checked. The values must not be greater than the maximum stroke
5.3.2 page
between the stops.

4.6. Loading the reciprocator

The equipment must be fixed by means of suitable fastening nuts on the vertical bar, which is
itself supported by the two horizontal bars fixed on the robot carriage. The powder projectors
must be 250 mm apart in height on the vertical bar. For a good functioning of the mechanism,
it is desirable that:
• the distribution and overhang of the admissible loads (50 kg maximum) are respected.
• the weight of the carriage, equipped with cables and pipes, is substantially balanced by
the weight of the counterweight with its weights.
Index revision : A 24
(A)
(B)
(see §
7140