Counterweight Adjustment; Antistatic Toothed Belt Tension Adjustment - SAMES KREMLIN Inorecip V User Manual

4.7. Counterweight adjustment

For a good working of the equipment, it is advisable that the weight of the carriage, equipped
with the cables and hoses of the projectors, is substantially balanced by the weight of the coun-
terweights equipped with its ballasts. This balance is achieved by adding or removing weights
that are accessible after removing the side panels of the Inorecip V.
Each ballast weighs approximately 1.8 kg. Tighten the 4 fixing nuts (M8) by counterweights after
changing the ballast.

4.8. Antistatic toothed belt tension adjustment

For correct operation of the equipment, it is
recommended that the antistatic toothed belt
on the carriage be correctly tensioned and alig-
ned.
• Remove the side panel.
• Move the carriage down to the lower stop
• Loosen the locking screw (A).
• Tighten the belt by tightening the 2 screws
(C).
• Apply a force F = 50 N on the belt and
control the tension distance according to
the table below:
Distance
Stroke between
(mm) pulleys (L)
(mm)
1200 2196
1500 2496
1800 2796
2100 3096
2400 3396
2700 3696
• Tighten the locking screw (A).
• Reassemble the side panel.
Index revision : A
Number of projector
2
4
6
8
10
12
Tension
distance (F)
(mm)
28
31,2
34,9
38,7
42,5
46,2
Number of ballasts
4
8
10
16
20
22
(A)
(C)
25
(B)
7140