Table of Contents
Advertisement
1.2. Simplified analysis of potential ignition sources according to EN 80079-36
Potential
Description / Main cause
source of igni-
(What are the conditions causing
tion
the risk of ignition)
Friction of the drive belt on the pul-
Hot surface
leys and of the rollers on the rails
Sparks caused by the fall of the car-
Sparks of
riages (belt breaking) or by a
mechanical
change in the stroke of the car-
origin
riages
Electrostatic discharge between
metal parts and earth (e.g. rollers /
Static electri-
rails, pulley / axis / belt)
city
Electrostatic discharge at the belt
1.3. Precautions for Use
This document contains information that all operators should be aware of and understand
before using the Inorecip V and Inomotion. This information highlights situations that could result
in serious damage and indicates the precautions that should be taken to avoid them.
WARNING : Before any use of the equipment, check that all operators:
• have previously be trained by the compagny SAMES KREMLIN, or by their distributors
registered by them for this purpose.
• have read and understood the user manual and all rules for installation and operation, as
laid out below.
It is the responsibility of the operators' workshop manager to ensure these two points and it is
also his responsibility to make sure that all operators have read and understood the user
manuals for any peripheral electrical equipment present in the powdering area.
1.4. Warnings
DANGER:
It is imperative that anyone wearing a pacemaker does not use the equipment and does not
enter the projection area.
High voltage can cause the pacemaker to malfunction.
WARNING : Safety may be jeopardized if this equipment is not operated, disassembled and
reassembled in compliance with the instructions given in this manual and in any
European Standard or national safety regulations in force.
Index revision : A
Risk of ignition
Measures applied to prevent the
source of ignition from becoming
Description of the measure applied
Plastic belt: does not transmit heat
Moving speed < 36m/min
Carriages equipped with high and low
elastic stops
All metal parts must be earthed.
Antistatic belt
6
effective
7140
Advertisement
Table of Contents
