Table of Contents
Advertisement
6. Maintenance
WARNING : Before any intervention on the Inorecip V, it is imperative to cut off the power sup-
ply.
6.1. Maintenance summary table
Therefore, the frequency of maintenance indicated in the procedures below is only indicative.
The user will have to create his own maintenance range as he uses the SAMES KREMLIN
equipment.
Procedure
Checking the condition, tension and alignment of the
A
antistatic toothed belt
B
Checking the free running of the carriage rollers
C1
Replacement of the antistatic toothed belt
C2
Replacement of coder
C
C3
Replacement of the rollers of the altitude carriage
Replacement of the rollers of the counterweight car-
C4
riage
6.2. Maintenance
WARNING : All cleaning operations must be carried out using compressed air only. Water
should never be used to clean the equipment.
After the first 100 and 200 hours, then every 1000 hours (or twice a year):
• Check the condition and tension of the belt and, if necessary, correct and clean it.
• Check the free running of the carriage rollers:
• Altitude carriage rollers: The rollers at the front bottom and rear top are subject to ove-
rhang forces from the projection equipment: they must not rotate freely. On the other
hand, the opposite rollers, i.e. the low rear and high front rollers, must be able to rotate
easily but without excessive play. Check this at several points along the stroke of the
carriage (as slight deformations of the railways may have been produced by the wel-
ding work.
• Counterweight carriage rollers: the rollers must be able to rotate easily but without
excessive free play. Check this at several points along the carriage stroke (as slight
deformations of the railways may have been caused by welding work).
• If necessary, change the position of the rollers. To do this: Slightly loosen the M5 locking
screw on the roller axis.
Index revision : A
Detail
Maintenance
Replacement
32
Dura-
Frequency
tion
30 min
twice a year
10 min
twice a year
45 min
-
20 min
-
45 min
-
45 min
-
7140
Advertisement
Table of Contents
