Axis Configuration - SAMES KREMLIN Inorecip V User Manual

Serial communication:
The Inomotion has an RJ45 connection that allows the module to be connected to a PLC. In
this case, the setting parameters of the module are processed directly via the PLC and the
Inomotion module is used as a "Slave".
Info code
IP address IP address of the device itself.
Subnet Subnet mask of the network to which the module is
Mask connected.
Gateway of the network to which the module is
Gateway
connected
Valid only when the module is defined as "Slave" in
networks. Defines the IP address of the master
Master IP module in the network. The operating parameters of
the module are copied from the master module
whose IP parameter is pointed to in this setting.
5.3.2. Axis configuration pages
After the Main Setup screen, the Setup screen allows to adjust the properties of the axis by
pressing the key (13). Pressing this key again switches to the settings of the other axes.
Info code
Axis type for vertical axis =
OSC (for oscillation)
Max POS.
Min POS.
HOM. Retard
HOM. Freq.
Max. Freq.
Max V (Speed)
Min V
V recommended
Max a (acceleration)
Min a
a recommended
HOM. T. Out
MOT. T. Lim
ENC. 1P. mm
1 Hz/V
Index revision : A
Settings
Vertical axis
0/10
1200/1500/1800/2100/2400/2700
0
50 ms
10 Hz
75 Hz
36 m/min
6 m/min
20 m/min
2
2,5 m/s
2
0,5 m/s
2
1,5 m/s
30
120
0.26043925
0.48715338
28
Factory preset
192.168.0.200
192.168.0.1
192.168.0.1
192.168.0.100
Horizontal axis
POS.
1000
0
0
10 Hz
50 Hz
8 m/min
4 m/min
5 m/min
2
2,5 m/s
2
0,5 m/s
2
1,5 m/s
30
120
0.27286458
0.50666928
7140