Table of Contents
Advertisement
5.4. Main menu page
Each parameter can be selected with the keys
(5,6,7,8,9) on the right-hand side and change
their values with the rotating button (10).
1st line: Setting of the upper inversion point. The
maximum value is set on the configuration page.
2nd line: setting of the lower inversion point. The
minimum value is zero, or the value set on the
configuration page.
3rd line: Speed setting.
4th line: Acceleration setting.
5th line: indicates the number of the selected
program.
Note: The programming of the tables is described in chapter 5.5. To set up a new axis, press key
(13), the number of the axis concerned is shown on the left side of the screen.
5.5. Creation and operation of programs
The Inomotion can store up to 50 programs in memory.
Creation of programs;
1. In the "Main Menu" page, after having set the operating parameters of the axes, press key
(9) and hold it down for 2 seconds.
2. Set the number of the program to be stored, turn the setting rotating button (10) and select
the desired program number.
3. Save the program by pressing and holding down the key (9) until the program number flashes
rapidly and then release.
4. Press and hold down the key (9) until the program number starts flashing. Keep pressed until
it starts flashing at short intervals.
Activating programs;
1. To activate the stored program, press key (9) once.
2. Turn the setting rotating button (10) to select the desired program number
Index revision : A
1500
13
1
V
a
29
5
6
0
7
20.0
8
1.5
9
--
10
7140
Advertisement
Table of Contents
