Important Recommendations; Installation Of The Inorecip V Reciprocator; Maximum Speed Of Inorecip V; Vibrations Of The Inorecip V - SAMES KREMLIN Inorecip V User Manual

13 Switch off all electrical or electrostatic equipment immediately, even if you are exposed
to a slight electric shock. Do not restart the equipment until the problem has been dia-
gnosed and resolved.

1.5. Important recommendations

1.5.1. Installation of the Inorecip V reciprocator

The Inorecip V alone or mounted on an Inorecip H must be installed on a flat floor with a resis-
tance of 40 daN/cm2.
It is better to equalize the loads on both sides of the assembly. If this is not possible, the admis-
sible overhang must not be more than 30 cm from the robot axis.
If the load cantilevered towards the front of the assembly, the distance of the center of gravity
of the assembly from the fixing tube must not exceed 10 cm.
The allowable loads on the Inorecip V assembly are 50 kg at a speed equal to 36 m/min for
assemblies dedicated to powder installations.

1.5.2. Maximum speed of Inorecip V

The Inorecip V has a maximum speed equal to 36 m/min at 50Hz.
WARNING : Access to the work area, when using the Inorecip, must be regulated and/or limited
by means of a standard protective wire mesh enclosure.
WARNING : The warranty does not cover damage resulting from higher sweep speeds.

1.5.3. Vibrations of the Inorecip V

If the assembly vibrates unusually, it usually means:
• Loose or worn belt.
• Loads too high and/or too eccentric (too much overhang).
WARNING : The warranty does not cover damage caused by loads higher than recommended
and/or with an overhang higher than recommended.
WARNING : The start-up and use of the Inorecip V must be in accordance with the Machinery
Directive and the EN 60204-1 standard (safety of machinery).

1.5.4. Inomotion installation

The Inomotion control module will be integrated in a control cabinet outside of any explosive
area. It will be connected to the Inorecip V and Inorecip H (option) by a set of cables supplied
by SAMES KREMLIN.
WARNING : it is imperative to connect the Inomotion to the ground of the control unit or to a
good quality ground.
Index revision : A 8 7140