Table of Contents
Advertisement
2. Introduction
2.1. General - Inorecip V
The Inorecip V reciprocator is designed to equip automatic powder coating installations.
It is composed of a mechanism controlled by an Inomotion control module placed in an elec-
trical cabinet.
It allows to drive, with a vertical reciprocating movement, powder projectors, for example:
• 12 Inogun A powder projectors,
• 4 Inobell powder projectors.
In case of use with a booth, to avoid crushing of limbs (fingers, hands...) between the projectors
and the booth, it is imperative to install and adjust the limit stops at the upper and lower parts
of the stroke as well as protective barriers around the equipment.
2.2. General - Inomotion
The Inomotion control module allows to remotely control the vertical reciprocating mechanism
of the Inorecip V and the horizontal positioning of the Inorecip H (option).
It is connected by power and control cables to the box located at the rear of the Inorecip V.
2.3. Inorecip H (option)
The In and Out carriage Inorecip H is an unit placed under the Inorecip V reciprocator giving
it the possibility to move along a second horizontal axis.
The Inorecip H allows to keep a constant coating distance whatever the width of the parts. It is
controlled via the Inomotion control module, which receives information from the part width
detection system.
This second axis is also often used for the automatic cleaning mode of the projectors.
Inomotion
Power and
control cables
Index revision : A
11
Inorecip V
Electric box
Inorecip H
7140
Advertisement
Table of Contents
