Power Supply (Ps) Interconnect Cable - Lincoln Electric FineLine 12864 Operator's Manual

FineLine 300HD Plasma System
Error Status
Code Light
10023 815 Cooler Level Fault
10025 825 Switchboard Thermistor Not
Connected
10026 751 Switchboard A Thermal Error
10027 752 Switchboard B Thermal Error
10029 64 Safety Circuit Not Ready
10030 299 N2 Over Pressure
10031 299 O2 Over Pressure
10032 299 H17 Over Pressure
10033 299 Air Over Pressure
10034 299 Argon Over Pressure
10037 492 Gas MUX Missing
10038 491 CAN Fault
10039 45 Secondary Over Voltage
10063 Other Power Source Fault
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
Power Supply Specific Errors
Description
Page 88 of 118
BK8053-000107 Rev A.01
Possible Resolution
5) Check the coolant filter cartridge
and replace if dirty.
1) Check for coolant leaking from
supply and return hoses, ASC, torch
leads, and torch connections.
2) Add coolant to the reservoir until
it reaches the bottom neck of the
reservoir.
Check that the thermistor is plugged
into each switchboard.
1) Check for blockage of the inlet
and outlet vents to the power
sections.
2) Check that power section fans
are operating properly.
EStop activated.
Adjust gas regulator until pressure
is within specifications. Refer to
Section 2.6.
Check wiring between control board
and gas mux PCB.
Check the Power Supply
interconnect cable.
Read the error conde blinking on
the front of the power supply and
report the fault to Lincoln Electric
service department for assistance.