Lincoln Electric FineLine 12864 Operator's Manual page 57

BK8053-000107 Rev A.01
4.3.5 View and Install Torch Parts
Press the View Torch Parts button to see the required consumables to cut or mark
based upon the active selections on the Material screen. The picture and part
number of each consumable are displayed for reference.
Use this information to build up the torch with the necessary consumables. Refer to
Section 5.6 for the complete procedure.
Press Cancel to return to the Material screen.
4.3.6 Confirm Cutting/Marking Parameters
Press the Parameters button to confirm the cutting and marking parameters. The
default values are determined by the active selections on the Material screen.
Press the data entry button (
operator's experience. Any changes to Material Type, Thickness or Process will
reset all cutting/marking parameters to default values.
Prior to making a cut or mark with the System, confirm the torch height control and
CNC are configured using the displayed parameter values.
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
) to change the values to suit the application or
Page 57 of 118
FineLine 300HD Plasma System