Lincoln Electric FineLine 12864 Operator's Manual page 68

FineLine 300HD Plasma System BK8053-000107 Rev A.01
Thread the retaining cap onto the torch until it is fully seated.
Apply lubricant to the o-ring on the shield cap. Push the shield cap onto the
retaining cap until it is fully seated or push the shield cap into the outer cap
until it is fully seated.
Apply lubricant to the o-rings on the torch. Thread the outer retaining cap
onto the torch until it is fully seated.
Apply primary (wall) power to the System.
End of procedure.
Swirl Retaining Shield Outer
Torch Electrode Nozzle
Ring Cap Cap Cap
Step
11
Step 10 Step 12 Step 13 Step 14 Step 15
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
Page 68 of 118