Cutting Charts - Lincoln Electric FineLine 12864 Operator's Manual

BK8053-000107 Rev A.01

5.7 Cutting Charts

The cutting charts shown on the following pages are intended to give the operator
the best starting point to use when making a cut on a particular material type and
thickness. Small adjustments may have to be made to achieve the best cut. Also,
remember that the arc voltage must be increased as the electrode wears in order to
maintain the correct cutting height.
Material (Grade)
Mild Steel (A36)
Mild Steel (A36)
Mild Steel (A36)
Mild Steel (A36)
Mild Steel (A36)
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
Cutting Chart Index
Current Plasma Gas
30 Amps Oxygen
80 Amps Oxygen
140 Amps Oxygen
200 Amps Oxygen
300 Amps Oxygen
Page 69 of 118
FineLine 300HD Plasma System
Page
Shield Gas
Reference
Oxygen Page 70
Air Page 71
Air Page 72
Air Page 73
Air Page 74