OLT STU128 Assembly Manual page 42

86.
Position 4AL - Transom Window
Trim around window, doing a dry run first.
Attach with as per Step 85 with
4 - 1 1/2" Finishing Nails per large piece
and 2 - 1 1/2" Finishing Nails per short
piece. Complete other side window.
87.
Position 4AM - Center Transom Window Trim around
window doing a dry run first. Attach horizontal trim first and
then the verticals with 4 - 1 1/2" Finishing Nails per piece.
Stemmed Assembly.
88.
Locate Door Knob Package. Included in the package will be the Stemmed Assembly, Interior
Knob, Latch Slant Bolt, Strike Plate and Screws (Phillips Head Screw Driver Required). Insert Latch
with Slant Bolt facing to the interior of the shed. Install Stemmed Assembly. Install Interior Knob with
screws (Robertson Screw Driver may be required). Install Strike Plate on Door Casing.Open and close
door and make any adjustments necessary.
Toll Free 1-888-658-1658
(1 Top piece - 41" angle ends) x 2
(2 Side pieces - 10 5/8" sq.cut) x 2
Horizontal pcs.1st.
Interior Knob.
Latch Slant Bolt.
www.outdoorlivingtoday.com
Parts
4AL - Transom Window Trim
(1 Bottom piece - 40" sq.cut) x 2
Tight underneath
soffit.
Vertical trim will
sit slightly inside
vertical door trim.
4AM - Center Transom Window Trim
(Top & Bottom pieces - 35 3/4" sq. cut) x 2
Interior Knob.
Page 42
Hardware
N1 - 1 1/2" Finishing Nails
x 24 total
Parts
(Side pieces - 20 1/2" sq.cut) x 2
Hardware
N1 - 1 1/2" Finishing Nails
x 16 total
sales@outdoorlivingtoday.com
Strike Plate.