Table of Contents
Advertisement
14.
Carefully lay 2B - Solid Wall Panels face
down. Position and attach 2C - Bottom Wall Plates
to bottom of wall studs of each wall panel with
3 - 2 1/2" Screws. Position so plates are flush with
framing.
15.
Starting at Rear Corner, position a Solid Wall Panel on top of plywood floor. The Wall Panel bottom
framing will sit flush with plywood. Wall siding will overhang the floor.
Rear Wall Panel
16.
The rear wall panels will sit even with the floor frame and the sidewall panels will be sandwiched
between the front and rear wall panels. The floor plywood may be slightly recessed.
Note: Siding will overhang the floor frame by approximately 3/4".
Toll Free 1-888-658-1658
You can find BR1 -
Square Drive Bit for
the screws in with the
Hardware Kit Bag.
Bottom Wall Plate
2B - Solid Wall Panels
(45 1/2" wide x 75" high) x 7
2C - Bottom Wall Plates
(1 5/8" x 2 1/2" x 45 3/8") x 7
Important: Make sure all walls are aligned in their
upright position. If not, water may leak into your shed.
Unsure if panel is facing up or down?
Check siding on window wall panel to match alignment.
Outside 2x3 framing of wall panel should
be positioned flush with the outside of
floor framing when properly aligned.
www.outdoorlivingtoday.com
Page 12
Parts
S1 - 2 1/2" Screws
sales@outdoorlivingtoday.com
Ensure bottom plate
is flush side-to-side
with wall studs
Hardware
x 21 total
Siding over-
hangs floor
frame by 3/4"
Advertisement
Table of Contents
