Front - OLT STU128 Assembly Manual

Side Facia
(11° cut ends).
Front Facia.
62.
Locate 4L - Front/Rear Facia & 4M - Side Facia. Start
by positioning one front facia up against front end of rafters.
63.
Next, have your helper place an angle cut Side Facia Board up tight
under shingles and flush against nailing strip and plywood sheathing. Line
front facia up so it caps the side facia. With front facia correctly aligned,
attach front facia to rafter ends with 8 - 1 1/2" Finishing Nails. Attach side
facia to edge of nailing strip and plywood edge with 5 - 1 1/2" Finishing
Nails.
64.
Align and attach remaining front facia as per Step 63. Align next two side facias on opposite side as
first side facia. Once again, do a dry run before attaching. There will be a Facia Detail Plate attached in
Step 67 to hide any gaps where facia pieces meet in the middle.
Toll Free 1-888-658-1658
Side Facia.
2 Nails per
rafter end
www.outdoorlivingtoday.com
Note: All Trim, Facia and Bottom Skirting pieces
will be positioned rough face out when installed.
4M - Side Facia - 11° cut ends (mirrored)
Do a dry run using side
and front facia to help
you correctly position
before attaching.

Front

facia caps
side facia.
Page 33
Parts (Steps 62 - 66)
4L - Front/Rear Facia
(3/4" x 5 1/2" x 72 3/4") x 4
(3/4" x 5 1/2" x 60") x 4
Hardware (Steps 62 - 66)
N1 - 1 1/2" Finishing Nails
x 52 total
sales@outdoorlivingtoday.com
Nailing Strip.