OLT STU128 Assembly Manual page 24

Longer overhang
43.
To assist in rafter alignment, you will need to assemble
the Rafter Spacer Jig (3 pcs made with plywood). Align the
center piece with the longer overhang of the side pieces as
shown above. Attach with 3 - 1 1/4" Screws in a triangular
formation per side. After using Spacer Jig to align the rafters in
Steps 44 & 46, it will be permanently fastened to the center of
the roof in Step 48.
44.
Place completed Rafter
Spacer Jig on top of the roof
rafters in the front. Position
interior rafters so they fit in jig
spacers as shown to the
right. Use the Front Rafter
Overhang Spacer to correctly
position rafters from front to
rear.
Expert Advice - prior to
attaching rafters, refer to
Step 36 and check that walls
are still level, square and
plumb.
Toll Free 1-888-658-1658
1 1/4" Screws
www.outdoorlivingtoday.com
Page 24
Parts
3D - Plywood Rafter Spacer Jig - Sides
(2 1/2" x 68 3/4") x 2
3E - Plywood Rafter Spacer Jig - Center
(2 1/2" x 48") x 1
Hardware
S2 - 1 1/4" Screws
x 6 total
sales@outdoorlivingtoday.com
Front Rafter
Overhang Spacer.
(14 1/2" long)