OLT STU128 Assembly Manual page 26

Exploded View of Roof Panels:
Small Roof Panel (2)
Large Roof Panel (3)
Plywood roof panel
overhang by 1 3/4"
48.
Locate and identify all 5 Roof Panels. Locate one 3G - Large
Roof Panel to begin. Carefully lift on rafters as shown above to see
how panel lines up. Roof Panel should land on center of third rafter and
be recessed 1/8" from edge. Roof Panel should overhang rafter facia by
approximatley 1 3/4" when lined up on center of third rafter.
Important: Before attaching roof panels pre-drill pilot holes with 1/8" bit to prevent splitting.
Attach to these rafters.
49.
Once Roof Panel is positioned correctly, secure to rafters with 18 - S2 - 1 1/4" screws. Before
attaching screws pre-drill pilot hole with 1/8" bit to prevent rafters from splitting. On the rear of the
shed start screws 3" from edge of roof panel, then space screws approximatley 16" apart. Be sure to
screw into center of rafter when attaching roof panels as shown above.
Toll Free 1-888-658-1658
Recessed 1/8"
from edge
Screw into center of rafters
when attaching roof panels
www.outdoorlivingtoday.com
Page 26
Center of third rafter.
Parts (Steps 48 - 53)
3G - Large Roof Panels
(48"wide x 86"long) x 3
3H - Small Roof Panels
(33" wide - 72"long) x 2
S2 - 1 1/4" Screws
Start screws 3" from edge of Roof Panel
sales@outdoorlivingtoday.com
Hardware
x 78 total