OLT STU128 Assembly Manual page 32

60.
Carefully lift one of the rear soffit sections and position underneath
rafters tight against soffit cap. Front edge of soffit (grooved edge) should
not extend past end of rafters. Attach with 6 - 1 1/2" Finishing Nails per
section. Position and attach remaining rear soffit pieces as per Step 58.
Position 4H - Rear Center Soffit Cap underneath rafters and over gap
where rear soffits meet. Attach center cap with 2 - 1 1/2" Finishing Nails.
61.
Position and attach 4I, 4J & 4K
- Top Horizontal Wall Trims. Top
trims are pieces of wall siding that
are ripped to 1" wide pieces. They fit
against the soffit and wall and finish
trimming the shed.
Use 3 - 1 1/2" Finishing Nails to
secure each trim.
Parts
4I - Front Top Horizontal Wall Trim
(3/4" x 1" x 39") x 1
4J - Front Top Horizontal Wall Trim
(3/4" x 1" x 48 3/4") x 2
4K - Rear Top Horizontal Wall Trim
(3/4" x 1" x 45 1/2") x 3
Hardware
N1 - 1 1/2" Finishing Nails
x 18 total
Toll Free 1-888-658-1658
Front Top Trim - 48 3/4" long.
Front Top Trim - 39" long.
www.outdoorlivingtoday.com
Page 32
Covers gap.
Parts
4H - Rear Center Soffit Cap
(1/2" x 3 1/2" x 5 1/4") x 1
Hardware
N1 - 1 1/2" Finishing Nails
x 14 total
Rear Top Trim 45 1/2".
sales@outdoorlivingtoday.com