Table of Contents
Advertisement
35.
When all walls are attached together, check alignment with the floor. Bottom
wall framing should sit flush with outside of floor framing. Adjust for best fit.
Confirm 38" wide door opening at top and bottom. When positioned correctly, fasten
bottom wall plates to floor using 4 - 2 1/2" Screws per wall panel. Check diagonal
measurement in each floor corner to confirm it is square.
91"
36.
Prior to installing rafters, take time to confirm your walls are level, square and plumb. Measure
diagonal at the height of back wall to opposing corner for square. If not within 1/2", your walls are not
square. Adjusting now will make it easier to install the roof section. Make sure front to rear inside frame
width is 91". Also check walls for plumb. Tip - once satisfied, cleat each corner temporarily with some
scrap wood (not included) to keep walls from moving.
Toll Free 1-888-658-1658
38"
www.outdoorlivingtoday.com
Page 21
Tape measure.
Check for plumb.
Temporary cleat.
sales@outdoorlivingtoday.com
Hardware
S1 - 2 1/2" Screws
x 36 total
Advertisement
Table of Contents
