How To Attach Xpansion Unit - Ko Propo EX-NEXT Instruction Manual

●Installation of Xpansion unit
Xpansion unit can be mounted facing the
front or the side. The factory setting is
mounted to the front.
Be careful to not misuse the M2.6-6BH and 2.6-8BH tapping
screws.
Remove the connector cover before use.
P Xpansion unit can be mounted in two different directions using
the monitor base and bracket.
A : Setting to the front
Attach a monitor base parallel to Xpansion unit.
*Factory setting.
Attention to the marker.
screw used.
M2.6-6BH
x 2
Attach the monitor bracket to the master unit.
*[A ]mark to the steering side.
Connect the wire of the
Xpansion unit to the
master unit.
screw used.
2.6-8BH
Tapping
x 4
Attach expansion unit to a master unit.
1
While matching the edge of the base with the
dent of the bracket, slide it until the Xpansion unit
locks.
screw used.
M2-6
Cap screw
x 1
A
1
2
2
Set M2-6 Cap Screw for
fixed.
▼B : When mounting sideways
Attach the monitor base at a right angle to Xpansion
Unit. *Different Factory setting.
Attention to the marker.
screw used
M2.6-6BH
x 2
Attach the monitor bracket to the master unit.
*Apply mark to the steering side.
Connect the wire of the
Xpansion unit to the
master unit.
screw used
2.6-8BH
Self tapping
x 4
screw
Attach the Xpansion unit to the master unit.
*Attach the monitor base and bracket as shown in figure.
How to disassemble the Xpansion unit.
1. Remove M2-6 Cap Screw.
2. Slide the Xpansion like shown in the figure below
and take off.
*The disassembly method is the same as side and front
positions
screw used.
M2-6
cap screw
x 1
When assembling or disassembling the Xpansion unit to
EX-NEX, please turn off the EX-NEXT.
6
Nut Holder
B
2
1