Pairing (For General Receiver) - Ko Propo EX-NEXT Instruction Manual

●Pairing
(for general RC car)
This operation allows the receiver to memorize the transmitter information. You must perform this when using a
receiver for the first time or when changing the EX-NEXT RF mode.
*There are two ways of pairing a receiver. Please use which ever method you feel is an easier operation.
<Pairing method 1>
A case of pairing method without changed RF mode.
1.
Preparing the transmitter.
While pushing the ET2 lever up, power on. The pilot LED
lights up, release ET2 lever.
Power ON
ET2
Please release the ET-2 lever when the initial screen is
displayed.
Change to pairing screen and start transmit power with
paring signal.
Change to pairing screen and start transmit power with paring signal.
ADV: Green / White TLMY: Blue / White
2.
Preparing the receiver
. Connect the receiver power source
while pressing the setup button.
. Check that the receiver's LED has lit up,
then release the setup button.
. Check that the receiver's LED lights up
again (indicating pairing completion
. Receiver's LED lights up again (about
3sec) and light off and start flashing.
It means searching for transmitter
signal.
3.
Preparations for Operation
.Turn off the transmitter and turn on again.
.Check that the receiver's LED lights up again (indicating
pairing completion)
<Pairing method 1 and 2 comon.>
If the LED flashes, the receiver is not getting
the EX-NEXT signal and the pairingprocedure
should be repeated.
Lit LED
BATT
Lit LED
Flash
<Pairing Method 2>
A case of pairing method with changed RF mode.
1.
Preparing the transmitter.
.Press ENT key when FUNCTION is selected at the Initial
screen.
MONITOR
STEERING
THROTTLE
FUNCTION
.Press ENT key when TLMY is selected at the FUNCTION
menu.
MODEL
3 - 8CH
.Press ENT key when RFMODE is selected at the Telemetry menu.
RFMODE
BT F/S
.Please set the RF MODE and WIDTH in the RF MODE
menu for you needs.
TIMER タイマー
RF MODE:
TIMER START
TRG START
WIDTH
LAP HISTORY
START/STOP KEY
LAP KEY
.Move the cursor to PAIRING and press and hold ENT key.
.Screen is change to the PARING and start sending the pairing
signal.
The EX-NEXT LED lights alternately in two colors
corresponding to
ADV: Green / White TLMY: Blue / White
2.
Preparing the receiver
.Turn on the receiver. And thereceiver's LED
will be start flashing.
.Check that the receiver's LED has lit up,
then release the setup button
.Check that the receiver's LED lights up again
(indicating pairing completion)
3.
Preparations for Operation
Press the Back key in the EX-NEXT.
Check that the receiver's LED lights up again (indicating
pairing completion)
19
XT-TMG DR5.8V
MODEL NO.01
STEERING THROTTLE
FUNCTION
KEYSET
TIMER
SYSTEM
TLMY
TELEMETRY
RESP RELICS
RF MODE TIMER
TLMY
:
GENERAL
OFF
PAIRING
OFF
点灯
BATT