Steering; Travel; St Travel; St Balance L R - Ko Propo EX-NEXT Instruction Manual

STEERING

STEERING

TRAVEL

Set the steering movement amount of the steering.
ST TRAVEL トラベル
ST TRAVEL：100
L 70％

ST TRAVEL

Change total movement of steering.
L(BALANCE)
Change the steering movement amount on the left.
R(BALANCE)
Change the steering movement amount on the right.

DIRECT BALANCE

Enables / disables the direct balance function.
ST TRAVEL
Adjust the overall amount of steering servo movement
when the steering wheel is at full lock.
Setting Range
ST TRAVEL : 0 to150
(Default : 100)
P Since the Balance setting value is a ratio of the
Travel setting value, if the latter is modified the actual
movement value and the displayed graphic will also
change.(the Travel value will not change).
Steering will not operate if the Travel value is set to 0.
N
R70%

ST BALANCE L R

Adjust the left/right steering angles independently.
This enables the turning radii to match up during cornering.
Setting Range
ST BALANCE L : 30 to 100
(Default : 70)
ST BALANCE R : 30 to 100
(Default : 70)
P The set percentage is a ratio of the value set by the
Steering Travel.
Steering balance can be adjusted by using
P
the steering wheel and ET key!
ET key that is assigned to steering trim is pressed while
the steering is turned over halfway in either direction, the
balance of the direction of the turn can be adjusted.
If the trim is set to a large value, a large left/right value
P
discrepancy may result. If adjusting steering balance for
the first time, follow the procedures below.
Set trim value to 0.
Adjust sub trim so that the car drives in a straight line when
steering is in neutral position.
Use steering travel to match the overall steering angle range.
Use steering balance to match the left/right turning radii.
If the car does not drive straight at this point, use trim to correct.
DIRECT BALANCE
ET key that is assigned to steering trim is pressed while the
steering is turned to full lock in either direction, the balance of
the direction of the turn can be adjusted respectively.( Steering
Trim: initial setting is ET1)
Setting Range
DIRECT BALANCE : ON to OFF
(Default : ON)
P
You can disable this function by set to "OFF" in the direct
balance.
46