Colored Grip And Pad Replacement; Unit Connector; Power Switch; Charging Jack - Ko Propo EX-NEXT Instruction Manual

●Colored Grip and Pad Replacement
Colored grip pad (optional) and Large/small grip pad
options are available.(LDT requires a another product)
<How to Adjust>
Remove the two screws on each side of the grip to detach the
grip plates, then attach the colored grip and pad.
Insert the color pad / grip claws into the holes in the following
order. Note direction of these parts.
③
①
②
Make sure the battery box or battery pack is removed before
replacing the colored grip and pad.
Be sure to attach it with the color pad to be replaced and the screw
of the length that matches the grip. If you make a mistake, the
battery or battery may be damaged.
Be careful not to overtighten the aluminum screws, as the screws
may be damaged if they are overtightened.
Note direction of the grip plate.
●Unit Connector
This product may be dismantled and therefore each unit
features their respective connectors. Dirty or damaged
connectors may result in malfunctions, so please handle them
carefully.
Do not touch the unit connectors with your fingers. If connectors
become corroded due to grime, they may become inoperable. If
storing the transmitter in dismantled form. After prolonged use, a
black residue may build up on the connectors. Use cotton swabs
dipped in cleaning alcohol to remove. KO Propo's Customer
Service Department also handles transmitter maintenance.
●Power Switch
This product features a safety lock. The Master Unit and Grip
Unit cannot be detached when the Power Switch is in the ON
position. Turn off the transmitter before dismantling.
Disassembly is not possible when the power is switch ON.
Forcefully trying to remove the Grip Unit while on will result in
damaging the locking mechanism.

Power Switch

●Charging Jack
Using the charging jack, you can charge different batteries.
When using the Xpansion and an expert grip unit,A battery
stand, a rechargeable battery, a battery charger are necessary.
<How to Recharge>
.Confirm that the power switch is in the OFF position. If only
using the Grip Unit, make sure that the connector cover is
in place.
.Make sure the battery is securely connected. If the
connection is loose, the battery may not charge completely.
Securely connect the charger plug to the charger jack.
.Begin charging using a current of less than 1A.
Please use charger which can set current less 1A and it must
P
correspondent your kind of battery. You can use No.55055 TX
charging jack2 as chaging plug.(sold separately)
Make sure the power switch is in the OFF position when charging.
A short circuit may occur if the connector makes contact with metal
and lead to a serious accident.
Use a current of less than 1A to charge.
Take note of the charger plug's polarity in order to avoid damage.
Do not attempt to charge if using alkaline batteries.
Doing so may result in battery leakage or cracking which will
damage the transmitter.
You can not charge the battery through the charging jack when
using a battery pack.
If using a battery pack, please note that it cannot be discharged via
the charger jack. Remove the battery pack from the transmitter to
discharge it.
After reading the battery pack manual, please use your battery.
discharged via the charger jack. Remove the battery pack from the
transmitter to discharge it.
12
Quick charger(Sold Separately)