For Safe Operation - Ko Propo EX-NEXT Instruction Manual

■ For Safe Operation

■ For Safe Operation
Due to the nature of radio controlled models, improper handling may lead to dangerous situations. Therefore please read the
following information carefully in order to ensure safe operation. Please also understand that KO Propo is not responsible for any
injuries or damage which result from noncompliance of these cautions and notices.
Warning!
Improper handling/
usage may lead to a high probability of material damage as well as a possibility of
serious personal injury or even death.
Notice!
Improper handling/
usage may lead to personal injury or material damage.
●When Installing Components
Warning!
Prohibited matters
Warning!
Enforcement matters
●Notes for Usage
Warning!
Prohibited matters
Warning!
Enforcement matters
●Make sure metal parts on the model (car chassis/ship hull) do not come into contact with
each other.
*Contact between metal parts may result in noise, which could cause the receiver to
malfunction and lead to an uncontrollable model.
●Do not cut or bundle the antenna cable.
*This may lower the receiver's sensitivity and lead to an uncontrollable model.
●Ensure correct polarity when installing transmitter and receiver batteries.
*Incorrect polarity may damage the product.
●Within Japan, this product is limited to usage with models which operate on the ground or
in the water.
*Do not use for other non-designated purposes.
●Ensure that all connectors (receiver, servo, switch, etc.) are connected securely.
*If connections become loose due to vibrations, it may lead to an uncontrollable model.
●Securely attach receiver with thick double-sided tape and ensure that it does not make
contact with other parts.
*Strong shocks or contact with other parts due to vibrations may lead to an uncontrollable
model.
●Check servo operation to ensure the push rod is not subject to excessive loads.
*Excessive loads may damage the servo or increase battery power consumption.
●Make sure to use the rubber grommet when attaching the servo and that the servo does
not contact the R/C equipment tray.
*If vibrations affect the servo, it may lead to damage or an uncontrollable model.
●Use in conjunction with genuine official KO Propo products.
*KO Propo is not responsible for any damages or injuries which result from use of this
product in combination with other manufacturer's products.
●Do not use when there is thunder.
*It is possible for lightning to strike the antenna.
●Do not use in the rain or in areas where water has accumulated.
*If water enters the product it may lead to an uncontrollable model.
●Do not use in the following locations:
1. Near R/C circuits (within 3km)
2. Near crowds, on streets, or near actual vehicles or ships.
3. Near high-voltage power lines or communication facilities.
*If signal interference, etc. causes an uncontrollable model, a serious accident may result.
●Do not use when your concentration levels are compromised by tiredness, alcohol,
medication, etc.
*Mistakes in judgment may result in serious accidents.
●Do not allow glow engine fuel or engine exhaust to contact the product.
*These may attack the plastic and damage the product.
●Check to ensure that the selected model memory matches the model to be controlled.
*Using an incorrect memory may lead to an uncontrollable model.
●Make sure to stop the engine (disconnect motor cables) before changing transmitter
settings.
3