Fail-Safe Setting - Ko Propo EX-NEXT Instruction Manual

●Fail-Safe Setting
Fail-safe is when the receiver loses the radio signal of the transmitter and the function keeps channel 2
(throttle) in an optional position. The configuration is usually full brake or neutral.
Fail-safe function will be cancelled automatically when the receiver receives the signal from the transmitter.
After Pairing
Connect a servo or ESC to 2Ch on the
receiver which you want to set the fail-safe
1
2 setting.
3
4
B/S
to the 2 channel
Turn on the transmitter.
Turn on.
Turn on the receiver and check that each
device connected operates correctly.
Turn ON
Full Brake
We recommend setting the throttle
position for Fail-safe as listed below.
•When using an ESC with reverse
:Neutral
Neutral
•Gas powerd car
Hold the throttle
•ESC only forward
trigger to the position
:Neutral or Full brake
you want to set for
Fail-safe.
Press and hold the setup button longer
than 3 seconds while holding the position
of the throttle trigger to the desired Fail-
safe position at the same time.
Press hold over 3 sec
Please release the setup button on the
receiver after the LED light goes off.
The setting is saved when the LED light
comes back on again.
Release button after light goes
off.
Turn off the transmitter to check the
Fail-safe setting is correct and safe.
Please be sure to set the fail-safe.
If you change the position of the fail-safe operation, please set
again. We recommend to set it again even. if you modify the
car engine brake linkage.
21