Installing The Memory Module - AXIOMTEK IPC970 User Manual

IPC970 Series User's Manual
2.4

Installing the Memory Module

The IPC970 comes with four DDR4 U-DIMM sockets. Please refer to the following instructions
and illustrations for the installation of the RAM module.
Step 1 Turn off the system.
Step 2 Disconnect the power connector.
Step 3 Loosen 7 screws to remove the side cover from the chassis.
Step 4 Install the U-DIMM into the socket and push it firmly down until it is fully seated. The
socket latches are clipped onto the edges of the memory module.
Step 5 After installing the memory module, close the side cover back to the chassis and
fasten all screws. The installation is complete.
40 Hardware Installation