RMG TME400-VM VMF Series Operating Manual page 41

Nominal Pressure classes Lubricating device
diameter
DN25-DN150 All pressure classes
DN200 All pressure classes
DN250 PN10 to PN16
ANSI 150
DN250 PN25 to PN100
ANSI300 toANSI600
> DN300 All pressure classes
Also observe the notice plate on the housing.
In unfavorable conditions, e.g. with an accumulation of water and hydrocarbon con-
densate, as well as dust-laden gases, more frequent lubrication is recommended,
even daily in extreme cases (e.g. with continuous condensate formation).
Note
Recommended lubricating oil:
Shell Tellus S2 MA 10 or another oil with 2 to 4°E at 25°C.
As necessary (see below) optional
small oil pump
(push-button operated)
Small oil pump
(push-button operated)
Large oil pump
(lever operated)
Manual TME400-VMF · EN07 · December, 7
1 Introduction
Lubricant require-
ment
Every 3 months
6 strokes
Every 3 months
6 strokes
Every 3 months
2 strokes
th
2020
35