3 TME400
Caution
It is necessary to remove the seals, particularly the seal over the calibration
button in order to boot up (see Figure 8: Position of the calibration button).
The TME400 must only be used for custody transfer with unbroken seal. Re-
46
moval or damage to seals normally entails considerable expenses!
Re-application of seals must only be carried out by an officially recognized
inspection authority or calibration officials!
Note
The current parameter settings and meter statuses are lost when re-booting!
They are reset to standard values.
Therefore, prior to booting up, read and store all parameters of the TME400.
Manual TME400-VMF · EN07 · December, 7
Figure 8: Position of the calibration button
th
2020