Terminals; Terminal Blocks - Mitsubishi Electric MELSERVO-J2S-S061 Specifications And Instruction Manual

3. Terminals

3.1 Terminal blocks

Symbol
L , L , L Main circuit power supply
1 2 3
U, V, W Servo motor output
L , L Control circuit power supply
11 21
P, C, D Regenerative brake option
N
Protective earth (PE)
Signal
Main circuit power input terminals
1) 200V Class
Supply L
For a single-phase 230VAC power supply, connect the power supply to L1 and
L2 and keep L3 open:
Power supply
3-phase 200 to 230VAC,
50/60Hz
Single-phase 230VAC,
50/60Hz
Cannot be used for combination with the servo motor HC-SFS52•53.
2) 100V Class
Supply L1, L2 with the single-phase 100 to 120V 50/60Hz power.
Servo motor power output terminalss
Connect to the servo motor power supply terminals (U, V, W).
Control circuit power input terminals
1) 200V Class
Supply L11 and L21 with single-phase 200-230VAC, 50/60Hz power.
2) 100V Class
Supply L11 and L21 with single-phase 100-120VAC, 50/60Hz power.
Regenerative brake option connection terminals
C and D are factory-connected.
When using the regenerative brake option, always remove wiring from across
P-D and connect the regenerative brake option across P-C.
Do not connect.
Ground terminal
Connect this terminal to the protective earth (PE) terminals of the servo
motor and control box for grounding.
Description
, L and L with the following power.
1 2 3
Servo amplifier
MR-J2-10A to 70A
7
MR-J2-100A to 700A
L •L •L
1 2 3
L •L
1 2
BCN-B11127-479*