Ignition Coil; Testing The Ignition Coil; Ignition Coil Removal; Ignition Coil Installation - Club Car Precedent Villager 2 Maintenance And Service Manual

20

Ignition Coil

IGNITION COIL
See General Warnings on page 1-2.

TESTING THE IGNITION COIL

See Test Procedure 14 – Ignition Spark on page 18-28 and Test Procedure 15 – Ignition Coil on page 18-29.

IGNITION COIL REMOVAL

1. Remove screws (1) and fan housing (2) (Figure 20-8, Page 20-11).
2. Disconnect ignition coil primary lead wire (12) from spade terminal (13) on ignition coil (11) (Figure 20-12,
Page 20-14).
3. Remove two bolts (10) and pull ignition coil (11) from engine.
12
13
11
510
Figure 20-12 Ignition Coil

IGNITION COIL INSTALLATION

1. Position ignition coil (11) onto engine and tighten two mounting bolts (10) finger-tight at this time (Figure 20-12,
Page 20-14).
2. Rotate flywheel until its magnet is positioned directly under ignition coil (11). Use a bronze feeler gauge to set air
gap between ignition coil and flywheel magnet from 0.012 to 0.020 in. (0.3 to 0.5 mm) (Figure 20-13, Page 20-14).
3. Tighten ignition coil bolts (6) to 71 in·lb (8 N·m).
4. Connect ignition coil primary lead wire (12) to terminal (13) on coil (Figure 20-12, Page 20-14).
Page 20-14 2019 Precedent Villager 2 Maintenance and Service Manual
10
0.012 Inch
(0.304 mm)
512
Figure 20-13 Adjust Ignition Coil Air Gap
GASOLINE VEHICLE - ENGINE
6