Governor System; Transaxle Service; Lubrication - Club Car Precedent Villager 2 Maintenance And Service Manual

Electric vehicle with eric charging system gasoline vehicle with subaru ex40 engine
Table of Contents

Advertisement

24
General Information
WARNING
• With the switch in the MAINTENANCE position and the engine running, the vehicle may move suddenly
if the Forward/Reverse handle is shifted or accidentally bumped. To prevent this, chock the front and
rear wheels and firmly set the park brake before servicing or leaving the vehicle.
NOTE: Be sure to return the switch to the OPERATE position after servicing the vehicle, or it will not run with the
Forward/Reverse handle in either the FORWARD or REVERSE position.

GOVERNOR SYSTEM

The governor system regulates vehicle ground speed. It is mounted inside the transaxle and is driven by transaxle
gears. If any of the governor linkages are removed in order to service other components, readjustment of the governor
linkage is required. See Governor Cable Installation and Adjustment on page 21-9.

TRANSAXLE SERVICE

The transaxle is extremely durable and should require very little service under normal operating conditions. The only
service required is to maintain proper lubricant level. See Lubrication on page 24-2. Under normal operating
conditions, adjustment to the system should not be required.

LUBRICATION

There are two oil port plugs located on the right (driven clutch) side of the transaxle (Figure 24-2, Page 24-3). When
the vehicle is on a level surface, use the upper plug as a lubricant level indicator. Lubricant level should be even with
the bottom of level indicator hole. Use the lower plug for draining.
Oil Change – Transaxle
1.
When draining transaxle oil, remove both plugs to allow the oil to drain faster.
2.
Clean and reinstall the drain plug and gasket before filling the transaxle with new lubricant. Tighten drain plug to
17 ft·lb (23 N·m).
3.
Use a funnel when filling the transaxle through the lubricant level indicator hole. Fill with 67.6 fl-oz (2 L) 80-90
WT. API class GL or 80-90 WT. AGMA class 5 EP gear lubricant (or until lubricant begins to run out of the
level indicator hole).
4.
Install upper plug and gasket and tighten to 17 ft·lb (23 N·m).
Page 24-2
2019 Precedent Villager 2 Maintenance and Service Manual
GASOLINE VEHICLE - TRANSAXLE

Advertisement

Table of Contents
loading

Table of Contents