Returning The Stored Gasoline Vehicle To Service - Club Car Precedent Villager 2 Maintenance And Service Manual

3
Storage – Gasoline Vehicle
9. Thoroughly clean front body, rear body, seats, engine compartment, and underside of vehicle.
10. Do not engage the park brake. Chock the wheels to prevent the vehicle from rolling.

RETURNING THE STORED GASOLINE VEHICLE TO SERVICE

1. Restore the fuel systems to operation.
1.1. Remove the plug from the fuel tank vent.
1.2. Connect the vent tube to the fuel tank vent.
2. Connect battery and spark plug wire(s).
See Connecting the Battery- Gasoline Vehicles on page 1-3.
3. Place the Forward/Reverse handle in the NEUTRAL position and the neutral lockout switch in the MAINTENANCE
position. Crank the engine until fuel is pumped into the fuel injector and fuel lines and the engine starts. Turn the
engine off and return the neutral lockout switch to the OPERATE position. See following NOTE.
NOTE: Due to the oil added to the engine in preparation for storage, engine may smoke excessively for a short
time when it is run for the first time after storage.
4. Adjust tires to recommended tire pressure. See Vehicle Specifications – Electric and Subaru EX40 on
page 2-1.
5. Perform the Pre-Operation and Daily Safety Checklist on page 10-1 and the Performance Inspection on page 10-2.
Page 3-6 2019 Precedent Villager 2 Maintenance and Service Manual
GENERAL INFORMATION