Table of Contents
Advertisement
13
Charger Receptacle
CHARGER RECEPTACLE INSTALLATION
1.
Insert the wires through the hole in the bucket.
2.
Insert receptacle (2) into bucket.
3.
Install the three screws (1) that secure the receptacle to the bucket. Tighten screws to 16 in·lb (1.8 N·m).
4.
Connect 10-gauge red wire to solenoid. Tighten nut 72 to 84 in·lb (8 to 9.5 N·m).
5.
Connect 10-gauge black wire to controller B- terminal. Tighten bolt to 108 in·lb (12.2 N·m).
6.
Connect light blue wire to main harness at bullet connector with light blue wire.
7.
Install kick plate. See Kick Plate and Charger Receptacle Bezel – Electric Vehicles on page 4-9.
8.
Place the Tow/Run switch in the TOW position and connect the batteries. See Connecting the Batteries –
Electric Vehicles on page 1-4.
Page 13-14
2019 Precedent Villager 2 Maintenance and Service Manual
ELECTRIC VEHICLE - ELECTRICAL
COMPONENTS
Advertisement
Table of Contents
Troubleshooting
