Flywheel Removal - Club Car Precedent Villager 2 Maintenance And Service Manual

GASOLINE VEHICLE - ENGINE
3037

FLYWHEEL REMOVAL

1. Remove screws (1) and fan housing (2) (Figure 20-8, Page 20-11).
2. Hold flywheel (4) only, not fan (7), with strap wrench (5) and use a 24 mm socket to remove flywheel nut (8) and
flat washer (9) by turning it counterclockwise (Figure 20-9, Page 20-12). See following CAUTION.
CAUTION
• The flywheel nut has right-hand threads. Turn it clockwise to tighten, or counterclockwise to loosen.
• Do not damage the fan blades with the strap wrench. Do not place screwdriver or pry bar in the
fan blades.
3. Temporarily install flywheel nut (8) onto end of crankshaft to protect threads and to prevent flywheel (4) from
falling off while being pulled.
4. Detach flywheel (4) from crankshaft with a large, two-jaw puller.
5. Remove flywheel nut (8) and flywheel (4) from crankshaft.
6. Remove woodruff key (10) from groove in crankshaft.
4
10
Figure 20-8 Flywheel, Fan and Fan Housing – EX40
2019 Precedent Villager 2 Maintenance and Service Manual
1
2
8
9
7
20
Flywheel
3
6
1
Page 20-11