Table of Contents
Advertisement
ELECTRIC VEHICLE - BATTERY CHARGER
HANDLE INSTALLATION
Place handle (9) onto charger and seat it onto mounting bosses of charger. See following NOTE.
NOTE: The handle (9) features locating tabs to aid installation.
Secure handle (9) to charger with two torx screws (8). Tighten screws (8) to 39.8 in·lb (4.5 N·m).
FOOT REMOVAL
1.
Disconnect DC cord (1) from vehicle.
2.
Disconnect AC cord (2) from AC outlet.
3.
If mounted, detach charger from shelf or wall.
4.
Squeeze barbs on back side of foot (10) and push foot out of charger mounting tab. Repeat for other feet if
necessary.
FOOT INSTALLATION
1.
Push foot (10) into hole in charger mounting tab until the barbs come through and secure foot in place.
2.
If required, mount charger to shelf or wall. See External Charger Mounting on page 15-6.
2019 Precedent Villager 2 Maintenance and Service Manual
External Charger Repairs
Page 15-21
15
Advertisement
Table of Contents
Troubleshooting
