Test Procedures; Testing Basics - Club Car Precedent Villager 2 Maintenance And Service Manual

18

Test Procedures

TEST PROCEDURES
Using the following procedures, the entire electrical system can be tested without major disassembly of the vehicle.
WARNING
• If wires are removed or replaced, make sure wiring and wire harness is properly routed and secured.
Failure to properly route and secure wiring could result in vehicle malfunction, property damage,
personal injury, or death.
For some tests, the electrical component box cover must be removed to gain access to the various components that
are mounted inside the component box. See following WARNING.
WARNING
• Shorting of battery terminals can cause personal injury or death.
After test procedures are completed, be sure to replace the cover. See following CAUTION.
CAUTION
• Exposure to water and the elements may damage electrical components. Do not operate vehicle
without the cover properly installed.

TESTING BASICS

• Battery voltage will be referenced throughout the test procedures. Battery voltage is accessed in Test Procedure 1
– Battery on page 18-12.
• The MAINTENANCE/OPERATE switch, in the MAINTENANCE position, grounds and kills the ignition if the FNR
shifter is placed in FORWARD or REVERSE.
• The key switch powers the ECU, fuel pump, solenoid, lights, and the connected car device.
• The 2-amp fuse is powered by the key switch via the 10-amp ATM fuse and carries battery voltage to the connected
car device.
• The term "back-probe" refers to probing the side of a connector that the wire enters. This is usually done when
the connector must remain connected to a device. An alternative method is to use an insulation-piercing probe.
See following CAUTION.
CAUTION
• Be careful not to damage the wire or terminal when back-probing.
• When testing voltage, the battery must remain connected.
• When testing voltage, unless specifically directed to do otherwise in a procedure, connect the black (–) probe of the
multimeter to chassis ground.
• When testing resistance or continuity, turn off power to the circuit being measured and discharge any capacitor(s).
The presence of voltage can cause inaccurate readings.
Index of Test Procedures
1 – Battery
Page 18-10 2019 Precedent Villager 2 Maintenance and Service Manual
GASOLINE VEHICLE - TROUBLESHOOTING
AND ELECTRICAL SYSTEM