Table of Contents
Advertisement
GASOLINE VEHICLE - CLUTCHES
5.2.6.
Hold the fixed sheave of the clutch (5) and rotate the moveable sheave of the clutch one-third
turn counterclockwise (Figure 23-18, Page 23-16). The match marks made before disassembly
should now align.
5.2.7.
Use two wrenches and hold the bolt head (1) while tightening the cam press hub (6) to press the
cam onto the keyed shaft. Advance the press hub (6) until it is firm against the shaft end.
5.2.8.
Remove the cam press hub (6) and installation tool.
5.2.9.
Install the retaining ring (4) (Figure 23-15, Page 23-15).
NOTE: The retaining ring (4) can be reused if the O.D. does not exceed 1.607 in. (40.82 mm); otherwise, it must
be replaced with a new ring.
DRIVEN CLUTCH INSTALLATION
1.
To install the driven clutch, reverse the removal procedure. Make sure that the washer (2) is mounted with the
flat portion of the washer against the driven clutch (Figure 23-14, Page 23-13). Secure with a new bolt (1).
See following NOTE.
NOTE: The bolt (1) must be replaced with a new bolt containing a locking patch that will prevent the bolt from loosening.
2.
Tighten the bolt (1) to 18 ft·lb (24.4 N·m).
3.
Connect battery and spark plug wire(s).
See Connecting the Battery- Gasoline Vehicles on page 1-3.
2019 Precedent Villager 2 Maintenance and Service Manual
23
Driven Clutch
Page 23-17
Advertisement
Table of Contents
Troubleshooting
