Resetting Power - External Charger - Club Car Precedent Villager 2 Maintenance And Service Manual

ELECTRIC VEHICLE - BATTERY CHARGER
RESETTING POWER – EXTERNAL CHARGER
The triangular status indicator light on the charger comes on in a solid red state to communicate a significant
charger hardware or software failure. See Charger Status Indicators on page 15-4. Before replacing the charger,
however, reset the charger in case the failure was caused by a temporary situation. To reset charger power, take
the following steps:
1. Unplug the DC cord from the vehicle.
2. Unplug the AC cord from the AC power source.
3. Wait for the red light to go off, wait 30 seconds, then plug the AC cord into the AC power source.
4. When the blue AC status indicator light comes on, connect the DC cord to the vehicle.
5. If the triangular status indicator light comes on, contact your Club Car dealer. If the light does not come back
on, attempt to charge the car as usual.
2019 Precedent Villager 2 Maintenance and Service Manual
Charger Troubleshooting
Page 15-13
15