Belt Tension Adjustment For Efi Engines - Club Car Precedent Villager 2 Maintenance And Service Manual

GASOLINE VEHICLE - ELECTRICAL
COMPONENTS
DF
F1
1
3033
Figure 19-14 Starter/Generator Wiring

BELT TENSION ADJUSTMENT FOR EFI ENGINES

NOTE: To prevent belt slipping while starting an EFI engine, follow procedure outlined below which is best performed
by two people to expedite the process, but can be performed by a single individual if required.
The amount a starter/generator belt is tensioned varies between a used and new belt.
EFI engines have higher starting torque demands that require consistent belt tension to prevent slipping. Belt tension
should be checked periodically.
Locate gauge midway between pulleys.
2724
Figure 19-15 Belt Tension Gauge
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery- Gasoline Vehicles on page 1-3.
2. Access engine compartment.
– Remove seat and rear access panel (if equipped).
– Raise cargo bed (if equipped).
2
4
3
F2
2019 Precedent Villager 2 Maintenance and Service Manual
2725
Figure 19-16 Belt Tensioning Tool Installation
19
Starter/Generator
Page 19-13