Table of Contents
Advertisement
GASOLINE VEHICLE - ELECTRICAL
COMPONENTS
LOW OIL WARNING LIGHT
See General Warnings on page 1-2.
TESTING THE LOW OIL WARNING LIGHT
See Test Procedure 17 – Low Oil Warning Light (LED) on page 18-30.
LOW OIL WARNING LIGHT REMOVAL
1.
Disconnect battery and spark plug wire(s).
See Disconnecting the Battery- Gasoline Vehicles on page 1-3.
2.
Remove the instrument panel. See Key Switch Removal on page 19-18.
3.
Disconnect the wires from the low oil warning light (11) (Figure 19-23, Page 19-27).
4.
Press the retaining tabs and remove the low oil warning light from the instrument panel.
YELLOW
YELLOW/
WHITE
2436
Figure 19-23 Low Oil Warning Light
LOW OIL WARNING LIGHT INSTALLATION
1.
Push a new unit into hole in instrument panel until plastic tabs engage (Figure 19-23, Page 19-27).
2.
Connect yellow and yellow/white wires from the wire harness to the low oil warning light.
3.
Install the instrument panel.
3.1.
Connect the electrical connector (3) (Figure 19-19, Page 19-18).
3.2.
Position the instrument panel (2) on the dash assembly. Make sure tabs on upper edge properly engage
with the corresponding slots on the dash assembly. Ensure that there are no wires exposed or pinched
during positioning.
3.3.
Secure instrument panel to the dash assembly with three screws (1). Tighten screws to 1.8 ft·lb (2.5 N·m).
4.
Connect battery and spark plug wire(s).
See Connecting the Battery- Gasoline Vehicles on page 1-3.
11
2019 Precedent Villager 2 Maintenance and Service Manual
Low Oil Warning Light
Page 19-27
19
Advertisement
Table of Contents
Troubleshooting
