Manually Adjusting The Time Offset; Changing The Orientation Of The Projected Image - Christie CP4315-RGB User Manual

3. To automatically adjust the projector time to follow Daylight Saving Time, select
Automatically adjust for Daylight Saving Time.
The color of the slider changes to green to indicate it is active.
4. Select Save.

Manually adjusting the time offset

You cannot manually adjust the time offset if network time protocol (NTP) time synchronization is
active.
To turn off NTP time synchronization, select Service Setup > Time Setup, select the NTP Servers tab,
and then select the Time Sync via NTP Server slider. The color of the slider changes to gray to indicate
it is inactive.
1. In the left navigation menu, select Service Setup > Time Setup.
2. Select the SM Time Adjust tab.
3. Increase or decrease the time offset:
• To increase the offset in minutes and seconds, select Up.
• To decrease the offset in minutes and seconds, select Down.
The Digital Cinema Initiatives (DCI) specification does not allow time offsets greater than six
minutes in a calendar year.
4. Select Save.

Changing the orientation of the projected image

Change the orientation of the projected image from normal to inverted to support multi-projector
installations where deflection mirrors are used.
1. In the left navigation menu, select Service Setup > Preferences.
2. Select General.
3. From the Projected Image Orientation list, select the required orientation for the projected
image.
Orientation
Normal Front
Inverted Front
Normal Rear
Inverted Rear
Cinema 4K-RGB User Guide–CP4315-RGB, CP4320-RGB, CP4325-RGB, CP4330-RGB
020-102712-06 Rev. 1 (03-2021)
Copyright © 2021 Christie Digital Systems USA, Inc. All rights reserved.
Description
Projection from behind the audience with the projector in the normal, upright
position.
Projection from behind the audience with the projector in an inverted position
(upside down).
Inverted positioning is not supported for Cinema 4K-RGB projectors. For
more information, see the Cinema 4K-RGB Installation and Setup Guide
(P/N: 020-102710-XX).
Projection from behind the screen with the projector in the normal, upright position.
Projection from behind the screen with the projector in an inverted position (upside
down).
Operating the projector
25