Table of Contents
Advertisement
Results
User's manual
11. Press OK.
The pop-up window closes and the new value is displayed on the control
panel.
12. Press Program.
13. Press Auto forward to adjust the counter-clockwise rotation time of the
micromotor in the Auto forward mode.
A pop-up window opens.
14. Adjust the Auto forward time.
The maximum time is 6 seconds and the minimum 0 seconds, and the
time can be changed in steps of 0.2 seconds.
15. Press OK.
The pop-up window closes and the new value is displayed on the control
panel.
16. Press Instrument spray to toggle between water & air, air and no spray.
The amount of water and air can also be programmed.
17. Press Chip blow to switch the automatic chip blow on or off. The amount
of water and air can also be programmed.
18. Press Instrument light to switch the instrument light on or off.
NOTE
Changing the instrument spray, chip blow and instrument light values follows
the normal programming pattern. For more information, see sections
"Instrument spray" on page 181, "Automatic chip blow" on page 182 and
"Instrument light" on page 183.
When you have modified the settings of a preset, but have not saved them,
a dash (–) replaces the preset number on the control panel.
The procedure for saving the modified preset settings is explained in section
"Saving modified preset values" on page 188.
25 Programming
Planmeca Compact i
187
Advertisement
Table of Contents
