Event Control Function - JAI SW-4000T-10GE User Manual

Event Control Function

The Event Control Function is a function that outputs a signal change point inside the camera
as information indicative of an event occurrence (event message) by using GVCP (GigE Vision
Control Protocol).
■ Flow from detecting an event to sending an event message
Event signal
■ Events that can use the Event Control Function
Events that can use the Event Control Function are as follows. You can specify whether or not
to send an event message when an event occurs at each event.
Acquisition Start,
Frame Start,
Line Start,
Exposure Red Start,
Exposure Green Start, Exposure Green End,
Exposure Blue Start,
Line1 Rising Edge,
Line4 Rising Edge,
Line5 Rising Edge,
Line8 Rising Edge,
Line9 Rising Edge,
Line10 Rising Edge,
Line12 Rising Edge,
Line13 Rising Edge,
LVAL Start,
Detect an event
Interrupt signal
MCU inside the camera
Acquisition End,
Frame End,
Line End,
Exposure Red End,
Exposure Blue End,
Line1 Falling Edge,
Line4 Falling Edge,
Line5 Falling Edge,
Line8 Falling Edge,
Line9 Falling Edge,
Line10 Falling Edge,
Line12 Falling Edge,
Line13 Falling Edge,
LVAL End
— 41 —
Keep the event type and
timestamp value when an event
occurs.
SW-4000T-10GE
Reset event information after an
event message has been sent
Send an event message