⑥ DC IN/TRIG connector(12-pin round)
Connect the cable for a power supply (optional) or for DC IN / trigger IN here.
HR10A-10R-12PB(71)(Hirose Electric or equivalent )
Pin No.
Input/Output
1
2
Power In
3
4
5
In
6
In
7
Out
8
9
Out
10
In
11
Power In
12
Note
In order to operate at the maximum line rate, 10-25V DC power must be connected to
both Pin1/Pin2 and Pin 11/Pin12. If you supply power to only one pin pair, the camera
may operate at less than the maximum line rate or may not operate at all.
IMPORTANT! You must supply the same voltage to each pin pair. If you supply different
voltages to each pin pair, the power unit of the camera will be damaged.
TTL signal specification
TTL out signal specification (Typ.)
Output voltage:
Input/Output current:
TTL in signal specification (Typ.)
Input voltage:
Signal
GND
DC In
DC 10 V ~ 25 V
GND
RESERVED
Opto In 1 -
Line 5
Opto In 1 +
TTL Out 4
Line 12
NC
TTL Out 1
Line 1
TTL In 1
Line 4
DC In
DC 10 V ~ 25 V
GND
Low 0.0V
High 5.0V
+/-32mA
Low 0.0~0.8V
High 2.0~5.5V
— 9 —
Description
SW-4000T-10GE