JAI SW-4000T-10GE User Manual page 45

Item
c） Acquisition Control
Acquisition Mode Single Frame,
Multi Frame,
Continuous
Acquisition Start ー
Acquisition Stop ー
Acquisition Frame Count 1〜65535
Acquisition Frame Rate(Hz) ー
Acquisition Line Rate 66 〜
Trigger Selector Acquisition Start,
Acquisition End,
Line Start
Frame Start,
Frame Transfer Start
TriggerMode Off, On
TriggerSource PulseGenerator0
PulseGenerator1
PulseGenerator2
PulseGenerator3
UserOutput0
UserOutput1
UserOutput2
UserOutput3
Action 0
Action 1
Action 2
Action 3
Line4 TTL In 1
Line5 Opt In 1
Line10 TTL In 2
Line13 TTL In 3
Logical Block 0
Logical Block 1
Encoder Trigger
TriggerActivation RisingEdge
FallingEdge
Level High
Level Low
ExposureMode Off, Timed,
Trigger Width
ExposureTimeMode Common, Individual
ExposureTimeSelector
ExposureTimeMode:Common
ExposureTimeMode:Individual
ExposureTime 3 〜 15149
RBExposureInterlocked Off, On
Setting range Default value
Countinuous
ー
ー
1
66
66
Acquisition Start
Off
Line4 TTL In 1
Rising Edge
Timed
Common
Common
Common,
Red,
Green,
Blue
Off
— 45 —
Description
Configure image capture settings.
Select the image capture mode.
Start image capture.
Stop image capture.
In [MultiFrame] mode, set the number of frames to capture.
Display the frame rate as a frequency. (unit: Hz)
Set the AcquisitionLineRate (Hz).
The maximum value varies depending on the PixelFormat and ROI settings.
Select the trigger operation.
Select the trigger mode.
Select the trigger signal source.
Select the polarity of the trigger signal (i.e., location of signal at which
trigger is applied).
[Trigger Selector] = Line Start
ExposureMode is Off or Timed : RisingEdge, Falling Edge
ExposureMode is TriggerWidth : LevelHigh, LevelLow
Select the exposure mode.
Select the exposure time mode.
Select the sensor to set ExposureTime.
To set the common setting values for all three sensors, select Common
Set the exposure time.
When set to On, you can change Green while maintaining white balance.
SW-4000T-10GE