JAI SW-4000T-10GE User Manual page 13

③ LAN cable
Connect a LAN cable to the RJ-45 connector.
・ The camera supports the following Ethernet standards.
(1000Base-T, 2.5GBase-T, 5GBase-T, 10GBase-T)
・ The longest cable length varies depending on the type of LAN cable and the Ethernet standard.
Below, the table shows the relationship diagram between LAN cable type and Ethernet standard.
Correctly select the LAN cable type according to the Ethernet standard to be used.
■ About the longest cable length
LAN cable type
Ethernet standard
1000Base-T
2.5GBase-T
5GBase-T
10GBase-T
・ Refer to the specifications of the cable for details on its bend radius.
Caution
Secure the locking screws on the connector
manually, and do not use a driver. Do not secure
the screws too tightly. Doing so may wear down the
screw threads on the camera. (Tightening torque:
0.147 Nm or less)
④ Network card
Install this in the computer that will be used to configure and operate the camera.
Refer to the instruction manual of the network card, and configure settings on the computer as
necessary.
*) This camera can be powered over a LAN cable from PoE+ compliant power supply equipment
(network card, switching hub, injector).
The power supply equipment to be used should have an IEEE 802.3at Type 2 Layer 1
classification. For details, please contact the vendor of the power supply equipment.
Cat5e Cat6/Cat6e
100m 100m
100m 100m
-
100m
-
55m
— 13 —
Cat6A Cat7
100m 100m
100m 100m
100m 100m
100m 100m
Secure manually.
Do not secure too tightly.
SW-4000T-10GE