JAI SW-4000T-10GE User Manual page 56

Item
q） Shading
Shading Correction Mode FlatShading,
ColorShading
Shading Mode Off,
User1,
User2,
User3
Calibrate Shading Correction ー
Shading Calibration Result ー
Shading Data Selector Red, Green, Blue
Shading Data Index 1 〜 1024
Shading Data 0 〜 0x1FFFF
Shading Data Save ー
Item
r） Correction
Pixel Black Correction Mode Off, Default, User1,
User2, User3
Calibrate Pixel Black Correction ー
Pixel Black Calibration Result ー
Pixel Gain Correction Mode Off, Default, User1,
User2, User3
Calibrate Pixel Gain Correction ー
Pixel Gain Calibration Result ー
Off, Lens1, Lens2,
Chromatic Aberration Correction Mode
Lens3
Chromatic Aberration Correction R Channel,
Selector B Channel
Chromatic Aberration Correction
Setting range Default value
FlatShading
Off
ー
Idle
Red
1
0x4000
ー
Setting range Default value
Default
ー
ー
Default
ー
ー
Off
R Channel
-4.0 to +4.0
(0.1 step)
— 56 —
Description
Configure shading correction settings.
Select the shading correction method.
Set the area to which to save shading correction data.
When this is set to [Off], shading correction data is not saved.
Execute shading correction.
This command can not be excuted under the following conditions.
・When no image is output.
・Outputting TestPattern.
・When the ROI setting is under the following conditions.
(Width or Height are less than 128)
・Shading Mode is Off.
Display the shading correction results.
0:Idle
1:Succeeded
2:Error1 - Image was too bright
3:Error2 - Image was too dark
4:Error3 - Could not calibrated
Read the shading correction data and select the sensor to be changed.
Set the index table number for shading correction.
Display the result of shading correction.
Save the result of shading correction.
Description
Correct variations due to sensors and lenses.
Select the user area to which to save the black level correction value.
Generate black level correction data automatically from the captured image.
Caution
When [Pixel Black Correction Mode] is set to [Off] or [Default] and a test pattern is being output
instead of an image, this command cannot be executed.
Display the results of
[Calibrate Pixel Black Correction] execution.
The results will be one of the following.
0:Idle
1:Succeeded
2:Error1 - Image was too bright
3:Error2 - Image was too dark
4:Error3 - Could not calibrated
Select the user area to which to save the gain correction value.
Generate gain correction data automatically from the captured image
Caution
When [PixelBlackCorrectionMode] is set to [Off] or [Default] and a test pattern is being output
instead of an image, this command cannot be executed.
Display the results of
[Calibrate Pixel Gain Correction] execution.
The results will be one of the following.
0:Idle
1:Succeeded
2:Error1 - Image was too bright
3:Error2 - Image was too dark
4:Error3 - Could not calibrated
Correct the color aberration that occurs at the left and right edges due to
lens characteristics.
Specify the channel for which to perform[Chromatic Aberration Correction
Lens1,2,3].
0 Set the amount of correction for
[Chromatic Aberration CorrectionLens1,2,3].
SW-4000T-10GE